• Home
  • Net
  • Cisco Wireless Access Point from Lightweight Mode to Autonomous Mode
24 март2020

Cisco Wireless Access Point from Lightweight Mode to Autonomous Mode

Written by Super User. Posted in Net

AP that is running in Lightweight mode:

System image file is "flash:/ap3g1-k9w8-mx.124-23c.JA8/ap3g1-k9w8-xx.124-23c.JA8"

AP that is running in Autonomous mode:

System image file is "flash:/ap3g2-k9w7-mx.153-3.JC1/ap3g2-k9w7-xx.153-3.JC1"

If there is “LAP” or “CAP” in the part number, the AP is shipped in Lightweight mode.

Product/Model Number                 : AIR-LAP1262N-A-K9
Product/Model Number                 : AIR-LAP1242AG-A-K9

In Lightweight mode: 

AP#config t
^
% Invalid input detected at '^' marker.

You need move to debug mode:

AP#debug capwap console cli

But as for me better move to recovery mode:

---Push reset bottom

---Power on

---after 10 sec unpush reset bottom and go to recovery mode:

  set IP_ADDR 192.168.100.100
  set NETMASK 255.255.255.0
  set DEFAULT_ROUTER 192.168.100.1
  tftp_init
  ether_init
  flash_init
    
  tar -xtract tftp://192.168.100.101/images/c1140-k9w7-tar.124-21a.JY.tar flash:

  set BOOT flash:/c1140-k9w7-tar.124-21a.JY/c1140-k9w7-tar.124-21a.JY

Login